Depending on the cost. My understanding is that the vouchers will cost 5k+ for a bull tag. I would love to get one in NM for him but I doubt we will raise that kinda funds.
I have no doubt with the collective knowledge and contacts here we can make this happen for Dave.
With that being said, Dave hurt his knee pretty good last year and had to put off getting it fixed because he was caring for Lori. He has to work thru that this year, get it rehabbed, and in...
Yes and yes, I put down WY and MT as I have experience there and it’s central to most of the forum members if we do a HT camp so everyone can partake if they want.
If enough funds are raised the vouchers are nice. However with my talks with @Big Fin I'm not sure we will be able to afford that.
If you want to, the funds raised from this thread will pay for his hunt.
Tag/fuel/procssesing/taxidermy
That way he can focus on zeroing out Lori’s expenses he incurred.
I’ve had a few PMs in regards to party apps tentatively we could do either state. For Wyoming would like to find another with over seven points.
Montana it’s not my strong suit and I have to freshen up on average needed.
With the permission of @Dave N and @Big Fin we are changing Dave’s Go Fund Me.
Dave as most of you have read has had a rough start to his retirement with all the care and passing of his wife Lori. We want to help Dave with his healing and forward movement of life in retirement.
Dave has...
Drivetrain is completely rebuilt from the water pump to the tail shaft. Brand new wiring harness from Current Performance. Now on to phase two, install. 6.0l LS / 6l80e / GM246
I guess it comes down to I’m not happy with just MOA and be done.
All of my rifles were built by a gunsmith. 15 rounds of ammo to get to the sweet spot is insignificant from a cost perspective. My OCD would never let me be happy if it was a 1/2 MOA gun being fed 1 MOA ammo.
It depends on your reloading method.
If you do velocity node you need to tune with seating depth.
I’ve done 5 different seating depths on Barnes bullets starting at .030 off the lands at .020 increments. You can clearly see on the individual target groups tightening and opening back up as...
I’ve thought about that for our step brother we only know about. I doubt he would want to know the horror of how he got conceived then brought into the world by a 13 year old.
Hospice has been a blessing with Mom. Hopefully you get a nurse as good as we got. They are there 24/7 to guide you thru it. When you think it’s time they will be there to help. Don’t hesitate to pick up the phone to call them.
@Hams42 don’t swap shell holders to your primer tool. Have a separate one for each. Mark the one for your die and always keep it with your die after you adjust for your chamber.
Shell holders vary dramatically and can cause the issue if you are not using the same dedicated one all the time.